DOSAGE AND ADMINISTRATION

LMD (dextran 40) is administered by I.V. infusion only.

Dextran 1 should be administered prior to administration of clinical dextran solutions.

1.

In shock, it is suggested that total dosage not exceed 20 mL/kg for adults and adolescents, during the first 24 hours. The first 10 mL/kg may be infused as rapidly as necessary to effect improvement. It is strongly recommended that central venous pressure be monitored frequently during the initial infusion of the drug. Should therapy continue beyond 24 hours, subsequent dosage should not exceed 10 mL/kg per day and therapy should not continue beyond five days.

2.

In extracorporeal perfusion, the dosage of LMD used will vary with the volume of the pump oxygenator. LMD can serve as a sole primer or as an additive to other priming fluids. For adults and adolescents, generally 10 to 20 mL of a 10% solution (1 to 2 g) of LMD per kilogram of body weight are added to the perfusion circuit. Usually total dosage should not exceed 2 g/kg of body weight.

3.

In prophylaxis of venous thrombosis and thromboembolism, the dosage of LMD for adults and adolescents, should be chosen according to the risk of thromboembolic complications, e.g., type of surgery and duration of immobilization. In general, treatment should be initiated during surgery; 500 to 1,000 mL (approximately 10 mL/kg of body weight) should be administered on the day of operation. Treatment should be continued at a dose of 500 mL daily for an additional two to three days; then, according to the risk of complications, 500 mL may be given every second or third day during the period of risk, for up to two weeks.

4.

Infants may be given 5 mL per kg body weight and children 10 mL per kg.

Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. See PRECAUTIONS.

Note: When infusing concentrated LMD, the administration set should include a filter.

Instructions for use

To Open

Tear outer wrap at notch and remove solution container. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect solution quality or safety. The opacity will diminish gradually.

Preparation for Administration

(Use aseptic technique)

1.

Close flow control clamp of administration set.

2.

Remove cover from outlet port at bottom of container.

3.

Insert piercing pin of administration set into port with a twisting motion until the set is firmly seated. Note: See full directions on administration set carton.

4.

Suspend container from hanger.

5.

Squeeze and release drip chamber to establish proper fluid level in drip chamber.

6.

Open flow control clamp and clear air from set. Close clamp.

7.

Attach set to venipuncture device. If device is not indwelling, prime and make venipuncture.

8.

Regulate rate of administration with flow control clamp.

WARNING: Do not use flexible container in series connections.